8 -axis long Kunukune Dual arm (pole mounting parts)
Thanko
About This Product
A dual monitor arm that can be used side by side with two LCD monitors. Can be mounted on a pole with a diameter of 35mm. For those who want to add multiple arms to the pole they have.
* This product does not have a pole. Only the arm part of the optional product of "8 -axis Knenkune Arm".
■ Movement of arm
・ The arm with a 4 -axis is an 8 -axis monitor arm for two two sides.
・ If you extend from the pole to about 520 mm, and lower it to the front with the monitor facing the front, the folded arm will be 230mm behind the pole.
(It varies depending on the monitor size and angle)
・ The first axis near Paul is about 180 ° or more.
The second axis swings about 220 ° or more left and right.
(State without a monitor arm)
・ It is easy because it can be fixed simply by tightening the screw with the attached hexagon wrench.
・ You can place a monitor in your favorite height and position.
* The upper and lower movable range varies depending on the situation, such as the size of the monitor and placement locations to be installed.
■ Movement of the monitor part
・ The monitor is movable about 180 ° both up, down, left and right.
・ For rotation, it is possible to turn 360 °.
■ Installation unit
・ Many liquid crystal monitors are standardized to 75mm x 75mm and 100mm x 100mm.
・ This standard is called VESA standard.
・ Our liquid crystal monitor arm supports all models, VESA (Video Equipment Standardization Association) standard.
■ Cable wiring clip
・ As the amount extended by the arm, cables such as power supply and output from the monitor will interfere with the plastic.
・ If you use the cable wiring clip attached to the arm, you can wire the cable along the arm and hook it without hooking.
■ How to install
[1] Put the arm in the pole attached to the top plate.
[2] At the preferred position, tighten and fix it with the attached hexagon wrench.
[3] Put your monitor and arm on the tip monitor mounting part firmly with four screws.
[4] Completed
The axis of each arm can be adjusted to the desired hardness using a wrench.
-
-
Product
8 -axis long Kunukune Dual arm (pole mounting parts)