TAIYO Co., Ltd.'s Response Status
This product is registered by TAIYO Co., Ltd..
About This Product
■Features
- Basically the same as Vario Mix a above, but pump synchronization is done with a single arm, and the adjustment range of the pump volume ratio is limited to 1:1 to 1:2.
・Although this is a low-cost product with economic efficiency in mind, there are limits to the measurement range and discharge amount, so please check the specifications before contacting us.
■Main options
・Material tanks 2L, 4L, 12L, 20L, 36L, 45L, 60L, 90L, 120L.
・A wide variety of piston sizes, various stirrers, various mixers, pot life alarms, pump pressure monitoring systems, volume counters, tank upper and lower limit sensors, cleaning systems, supply pumps, heating/thermal insulation systems, plasticizer supply pumps, vacuum defoaming devices, etc. .
・Pump drive can be pneumatic, hydraulic, or air-oil conversion depending on the application. (It may also be driven by a servo motor)
■Main uses
・Electrical, electronic, OA equipment industry
Fluorescent lamp ballast potting, battery case sealing, solar panel box potting, underground cable bulkhead foam sealing, microwave oven window frame sealing, road luminous stud potting, resin transformer filling, insulator/cable joint casting, OA table edge injection We have many achievements including molds, adhesion of steel furniture, adhesion of honeycomb materials for office furniture, sealing of electromagnetic cookers, potting of sensors, sealing of copy machine toner cases, etc.
・Automotive industry
Engine belt cover seals, wire harness grommet casting, urethane bumper two-component painting, spray molding, undercoat spray, sheet spray adhesive application, etc.
・Housing and housing equipment industry
Adhesion of residential boards, adhesion of kitchen sink seals, coating of colored steel plates for residential use, adhesion of kitchen hanging shelves, gas water heater seals, adhesion of unit bath insulation materials, adhesion of flush tank insulation materials, adhesion of entrance doors, adhesion of laminated boards, etc.
・Architecture, civil engineering industry
Runway crack repair, buried pipe joint sealing, building crack repair, waterproof spray coating, etc.
·others
Non-sol adhesive coating for film laminates, constant supply of resin to centrifugal molding machines, etc.
■Notes
We have one each of Vario Mix 1A/2A and Economics D demo test machines.
-
-
Product
Dispenser Econo Mix continuous discharge series
Share this product
