Cylinder switch for hydraulic/pneumatic equipment Magnetic proximity type waterproof/contact WR type
TAIYO Co., Ltd.
About This Product
■Connection
- Do not use a load that exceeds the switch's operating voltage/current and maximum contact capacity.
- Do not connect the power supply directly to the switch. Be sure to connect via a specified load such as a relay or programmable controller.
- If a large amount of surge voltage is generated in the surrounding area, or if a coil (relay, etc.) that generates surge voltage is used as a load, install a protection circuit in parallel with the load to protect the switch.
- Please note that the operation confirmation lamp may not light up if the switch is used below the operating voltage and current.
■Wiring
- Do not apply loads such as bending or pulling to the switch cord. In particular, take measures such as fixing the switch cord so that no load is applied to the base of the switch cord.
- Do not connect the switch directly. The operation confirmation lamp may not light up or the load may not operate due to voltage drop caused by the switch itself.
- Do not connect switches in parallel. The signal is output normally, but the operation confirmation lamp may not light up.
・Keep the switch cord as far away from other electrical equipment as possible. If wires are bundled or wired close together, induced current will adversely affect the switch and load.
■Detectable cylinder piston speed
Please note that if the piston speed is too fast, the switch will operate, but the time it will operate will be short and loads such as relays may not operate.
■Installation location
・Do not use in locations where the cylinder may be exposed to cutting oil directly.
・In locations where strong magnetic fields are generated in the surrounding area, provide a magnetic shield with an iron plate, etc.
- Do not bring ferromagnetic materials (such as iron) close to the outer circumference of the cylinder body or near the switch. As a guide, keep the distance approximately 10 mm.
-
Product
Cylinder switch for hydraulic/pneumatic equipment Magnetic proximity type waterproof/contact WR type
-
Handling Company
TAIYO Co., Ltd.
-
Categories
1 Models of Cylinder switch for hydraulic/pneumatic equipment Magnetic proximity type waterproof/contact WR type
| Product Image | Part Number | Price (excluding tax) | Ambient temperature | Applicable load | Cord extraction direction | Format | Indicator light | Insulation resistance | Internal voltage drop | Leakage current | Load current range | Load voltage range | Maximum switching capacity | Protection method | Response time | Shockproof | Vibration resistance | Wiring method | Withstand voltage |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
WR505 |
Available upon quote |
-10~＋60℃ (However, no freezing) |
Small relay programmable controller |
Backward | With cord (5m) |
Red light emitting diode (Lights up when ON) |
100MΩ or more at DC500V megger (between case and code) |
2V or less | 0μA | AC: 3~20mA・DC: 3~40mA | AC: 5~120V/DC: 5~50V | AC: 2VA, DC: 1.5W | IP67G (JEM standard) (oil resistant) | 1ms or less | 294m/s2 (non-repetitive) |
Double amplitude 1.5mm, 10~55Hz (1 sweep, 1 minute) 2 hours each in X, Y, and Z directions |
0.3㎟, 2 cores, outer diameter φ4mm Oil-resistant cabtire cord |
AC1,500V, no abnormality for 1 minute (between case and code) |
Customers who viewed this product also viewed
Other products of TAIYO Co., Ltd.
View more products of TAIYO Co., Ltd.
About Company Handling This Product
- Japan