Cylinder switch for hydraulic/pneumatic equipment Magnetic proximity type heat resistant/contact SW013
TAIYO Co., Ltd.
About This Product
■Wiring precautions
1. When wiring, be sure to cut off the device power to the electrical circuit on the connected side. Workers may receive an electric shock while working. Also, the switch or load may be damaged.
2. Do not apply loads such as bending, pulling, or twisting to the switch cord. In particular, take measures such as fixing the switch cord to a tie rod, etc., to prevent load from being applied to the base of the switch cord.
・It may cause the cord to break. In particular, if a load is applied to the base of the cord, the electrical circuit board inside the switch may be damaged.
・When fixing to tie rods, etc., do not overtighten. This may cause the cord to break.
3. Make the bending radius as large as possible.
・It may cause the cord to break. Please take at least twice the cord diameter.
4. If the distance to the connection destination is long, secure the cords at intervals of about 20cm to prevent them from sagging.
5. When running the cord above the ground, protect it by passing it through a metal pipe to prevent it from being stepped on or being crushed under equipment.
- Doing so may damage the sheathing, causing wire breakage or short circuits.
6.The distance from the switch to the load or power supply should be within 10m.
・If the distance is 10m or more, a rush current will occur in the switch during use, which may damage the switch. For countermeasures against inrush current, refer to "Contact protection precautions" and take measures.
7. Do not bundle the cord with other electrical equipment's high-voltage lines, power sources, or power source cables, or wire them nearby.
- Noise from high voltage lines, power sources, power source cables, etc. may enter the switch cord and cause the switch or load to malfunction. We recommend protecting it with a shield tube, etc.
-
Product
Cylinder switch for hydraulic/pneumatic equipment Magnetic proximity type heat resistant/contact SW013
-
Handling Company
TAIYO Co., Ltd.
-
Categories
1 Models of Cylinder switch for hydraulic/pneumatic equipment Magnetic proximity type heat resistant/contact SW013
| Product Image | Part Number | Price (excluding tax) | Ambient temperature | Applicable load | Contact protection circuit | Indicator light | Insulation resistance | Internal voltage drop | Leakage current | Load current range | Load voltage range | Maximum switching capacity | Operating time | Protective structure | Return time | Shockproof | Vibration resistance | Wiring exit direction | Wiring method | Withstand voltage |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
SW013 |
Available upon quote |
-10~+130℃ (However, no freezing) |
IC circuit/small relay programmable controller |
None | None |
100MΩ or more at DC500V megger (between case and code) |
0V | 0μA | AC: 20mA or less, DC: 40mA or less | AC: 120V or less, DC: 30V or less | AC: 2VA, DC: 1.5W | 1ms or less | IP67 (IEC standard), JISC0920 (dust-proof/immersion-proof type) | 1ms or less |
294m/s2 (non-repeat) |
Double amplitude 1.5mm, 10~55Hz (1 sweep, 1 minute) 2 hours each in X, Y, and Z directions |
Rear exit (with 1.5m cord) |
0.3㎟, 2 cores, outer diameter φ3.9mm Heat-resistant silicone cabtire cord (blue) |
AC1,500V, 1 minute (between case and code) |
Customers who viewed this product also viewed
Other products of TAIYO Co., Ltd.
View more products of TAIYO Co., Ltd.
About Company Handling This Product
- Japan