Measuring instrument/load management device Checkman CM-7S
Fuji Controls Co., Ltd.
About This Product
Load management device exclusively for PLC control. Equipped with a set load arrival signal, allowing you to control the pushing load.
■Features
・2 point hold.
・Compare and judge whether two arbitrary points during pressurization are good or bad. You can check the comparison results for each.
・Upper and lower limit values can be set in memory in 4 patterns.
・Set load arrival signal.
- Outputs a signal to the outside when the preset load value is reached.
- Select from standard interfaces RS-232C, BCD, and D/A (voltage output).
・DIN size W96mm x H48mm x D127mm (excluding protrusions).
・2-point hold function (pass/fail judgment at two arbitrary points during pressurization)
・Set load reaching signal (signal is output externally when the preset load value is reached)
interface
■RS-232C
・EIA RS-232C compliant
・Communication protocol: Modbus RTU
・Synchronization method: Start-stop synchronization method
・Communication method: Full duplex phase
・Communication speed: 4,800bps, 2,400bps, 9,600bps, 19,200bps
・Data length: 7bit
・Start bit: 1bit
・Parity bit: Even number
・Stop bit: 2bit
・Signal names used: TXD, RXD, SG, CTS, RTS
・Character code: ASCII code
・Transmission control procedure: No procedure
・Delimiter: CR/LF
■D/A output
・Conversion method: D/A conversion method
・Resolution: 13bit equivalent
・Scaling: Digital scaling
・Output target: Arbitrary setting of display contents for analog output
・Circuit response speed: Response speed is 300μs or less (0-90% response)
■BCD output
・Output format: Open collector output NPN type
・Measurement data: Negative logic When logic is "1", transistor is ON
・Polarity signal: Negative logic When negative display, transistor ON
・Over signal: Negative logic When over display, transistor ON
・Print command signal: Transistor ON for a certain period every time measurement is completed (depending on sampling speed)
・Transistor: Voltage 30V max Current 10mA max
・Output capacity: Output saturation voltage 1.2V or less at 10mA
■Options
・Load cell extension cable 3m (model: PA-3M)
・Test report・Calibration certificate・Traceability system diagram Comes as a set with our load cell
-
Product
Measuring instrument/load management device Checkman CM-7S
-
Handling Company
Fuji Controls Co., Ltd.
-
Categories
1 Models of Measuring instrument/load management device Checkman CM-7S
| Product Image | Part Number | Price (excluding tax) |
|---|---|---|
|
|
CM-7S |
Available upon quote |
Customers who viewed this product also viewed
Other products of Fuji Controls Co., Ltd.
View more products of Fuji Controls Co., Ltd.
About Company Handling This Product
- Japan