Rule puller RP1 recommended for improving the efficiency of blade removal work
Yukosha Shito Trading Co., Ltd.
About This Product
■What is Rule Puller?
Have you ever experienced trouble when cutting a cutting die or Thomson die, such as the blade not coming out straight or the blade being rusty? If you use the Rule Puller RP1, you can easily remove rusted or corroded blades without damaging the plywood using leverage. Highly recommended for improving work efficiency.
■Features
・Since the blade is pulled out vertically, it does not damage the mold.
・Since the 8 pins are easily removable, it can be used for a variety of cutting dies.
・Do not put your hands directly on the blade during work to prevent injury.
-Claws are economical, durable, and easy to replace.
・Safe and easy-to-use design.
- Compatible with both right-handed and left-handed people.
■Customer testimonials
"When we tried using it on site, it was very well received. The traditional method caused damage to the wooden mold, but that was only minor and even a female operator was able to pull out the blade. Even male operators used to use a lot of force to pull out the blade, but I heard that by using the rule puller, they didn't have to use as much force and it took even less time.
■Nails
-Tighten the hexagonal screws that secure the claws before use. If the screws are not tightened loosely, the screws may be damaged.
- If you apply more than 270 kg of pressure to the handle, the screws that secure the claws may be damaged.
■Rusted or corroded cutting dies
When removing a rusted or corroded blade, turn the cutting die over and spray the blade with rust remover spray from the back, then remove the blade after the rust is removed.
■Friction adjustment between blade and claw
- If your nails are not able to grip the blade properly when you pull it out, tighten the screw on the white washer part a little to increase the pulling force.
- If you tighten it too tightly, not only will both the white washer and the washer inside be damaged, but the handle will also become too tight and the blade will not come out smoothly.
■Blade removal position
・When removing the blade, decide where to start. Start by pulling out approximately 3cm from the edge of the blade, then move to a position of 8cm and gradually pull out until the blade is completely removed.
- Excessive force will be applied if you try to pull out the long blade from the middle or all at once.
-
Product
Rule puller RP1 recommended for improving the efficiency of blade removal work
-
Handling Company
Yukosha Shito Trading Co., Ltd.
-
Categories
1 Models of Rule puller RP1 recommended for improving the efficiency of blade removal work
| Product Image | Part Number | Price (excluding tax) | Grip part | Lever | Rule puller | Weight |
|---|---|---|---|---|---|---|
|
|
Rule Puller RP1 |
Available upon quote | 50×28mm | 180mm | 1 unit 295×95×30mm | 1,500g |
Customers who viewed this product also viewed
Other products of Yukosha Shito Trading Co., Ltd.
View more products of Yukosha Shito Trading Co., Ltd.