All Categories
History
Price (excluding tax)
Response Rate
100.0%
Response Time
24.9hours
Relatively Fast Response
■ Overview "Pilodact 597-A" is a heat-resistant adhesive with excellent conductivity and thermal conductivity based on silver particles. Since the inorganic binder is used, it has excellent weather resistance and heat resistance compared to organic adhesives. It is used for adhesion of electronic parts and high vacant parts. In addition, since the out -gas does not appear after firing, it can be used in vacuum. Water base 1 liquid silver paste. ■ Characteristics "Pyro Duct 597-A" is a mixture of high-purity silver particles with inorganic binders and gives heat resistance. The conductivity and thermal conductivity are very good, especially in electrical resistance than the conductive adhesive based on the normal epoxy regin. It is a single -liquid (paste -like), and does not use organic resin or solvent, so there is no release of gas at high temperatures. ■ How to use Introduction or coating the surface of glue or coating with a shot blast or sandpaper, and completely remove dust, oil, shot blast, and sandpaper residue with a cleaning agent. Mix slowly and slowly so that the pyrodact is uniform and so that air does not enter. Apply thinly on the wearing body and stick together immediately. When the coating of the coatives is completed, dry at room temperature for about 30 minutes, and then fired in the furnace of 93 ° C 2 hours. Those that do not burn can be easily removed with hot water and soap. To lower the viscosity, use a dedicated lean 597-A-T. ■ Application example ・ Repair of printed circuit boards ・ Sensor used in the high and high school aerial ・ High temperature connector and special light source ・ Electromagnetic wave shield gasket ・ Installation of heated parts ・ IC chips, semiconductor parts, etc.
You can search for other models from each index. The displayed value is the value of the currently selected part number.
Electric resistance rate (ω • cm)
Filler
Heat expansion coefficient (cm/cm/℃ x 10^-6)
Heat resistance upper limit (℃)
Rust resistance
Thermal conductivity (W/m • K)
capacity
color
Component number of components
Density (G/CM^3)
Escape force (kgf/cm^2)
In -furnace -grilled heating firing
Mixed viscosity @25 ℃ (CP)
Pulling slick intensity (PSI)
Mixed volume ratio (main agent: curing agent)
Pot life (100g amount 25 ° C time)
Insulation (KV/mm)
Dedicated intensity (PSI)
Indirect dielectric
Part Number
Pilodact 597-AProduct
Conductive, heat -resistant, high -heat conductivity conductive or thermal conductivity adhesiveHandling Company
Edec Co., Ltd.Categories
| Image | Price (excluding tax) | Electric resistance rate (ω • cm) | Filler | Heat expansion coefficient (cm/cm/℃ x 10^-6) | Heat resistance upper limit (℃) | Rust resistance | Thermal conductivity (W/m • K) | capacity | color |
|---|---|---|---|---|---|---|---|---|---|
|
|
Available upon quote | 0.0002 | Silver | 17.3 | 927 | excellence | 9.1 | 25g, 50g wide plastic container | Silver |
Reviews shown here are reviews of companies.
Conductive adhesive CA series
Access Co., Ltd.
140+ people viewing
Conductive Paints2 models listed
Reviews shown here are reviews of companies.
Response Rate
100.0%
Response Time
24.9hrs
![Anti-fog/reducing dust adhesion Conductive super hydrophilic coating [GFT83]-GAST Giken Co., Ltd.](https://metoree.s3.ap-northeast-1.amazonaws.com/img/products-new/3007810202411281.png)
