Mold temperature controller MTCⅡ-6
Igarashi Manufacturing Co., Ltd.
About This Product
Simple is best. Mold temperature controller MTCⅡ series. As simple as possible. Extremely sturdy. Extremely high performance
This mold temperature controller is very popular locally because it is easy to use and has good temperature accuracy. We offer low-cost after-sales service using alternative machines and transportation that do not require travel expenses.
Igarashi Seisakusho's MTC II series uses our unique new structure to perform exquisite temperature control even in the temperature range where cooling (water supply) control is required, even though it is a direct cooling method, reducing temperature fluctuations and minimizing unnecessary heater ON times. High performance mold temperature controller. Each of our mold temperature controllers is carefully assembled at our factory.
Features of MTCⅡ
■Stable temperature control saves energy
Mold temperature controller MTCⅡ exquisitely controls temperature with a unique structure that emphasizes the balance between tank capacity, heater capacity, and water supply amount, and also emphasizes suppressing temperature unevenness during water supply. Temperature stability of ±0.3℃ has been achieved not only in the high temperature range controlled by the heater, but also in the medium and low temperature range controlled by the water supply.
Limited to cooling control, if temperature stability is poor, the temperature will drop significantly once the water is supplied. Then, turning on the heater will raise the temperature, but if it does not drop too much, you will be consuming unnecessary power. Depending on the usage situation, this number may be too large to ignore. In other words, stable temperature control leads to the saving of unnecessary electricity costs, so we believe that temperature stability during cooling control is important not only to stabilize the quality of molded products but also to reduce power consumption. Even when lowering the set temperature during molding, the temperature that drops below the set value is extremely small, so the occurrence of unexpected molding defects during that time can be greatly reduced.
■Long life simple design
The pump used in the mold temperature controller MTC II is manufactured by Grundfos, and other highly reliable parts are manufactured by major domestic manufacturers.The rational structure is designed to eliminate parts that are not directly related to performance. We aimed for a long life by keeping it to the minimum necessary.
-
Product
Mold temperature controller MTCⅡ-6
-
Handling Company
Igarashi Manufacturing Co., Ltd.
-
Categories
1 Models of Mold temperature controller MTCⅡ-6
| Product Image | Part Number | Price (excluding tax) | Applicable molding machine (estimate) | Control method | Cooling method | Dimensions (dimensions including fittings) | Discharge flow rate At the above pressure | Discharge pressure 50Hz/60Hz | Heat medium | Heater capacity | Main safety equipment | Motor output 50Hz/60Hz | Power supply | Pump type | Return port | Sending port | Tank capacity | Temperature control range/stability | Weight |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
MTCⅡ-6 |
$ 2,392.00〜 | 300t or less | Heating/cooling PID | Direct cooling | 690H×260W×546D (676D) | 42L/min | 2.6・3.7kg/cm² | Shimizu | 6kw | Upper and lower temperature limit alarm (buzzer), medium error (buzzer), pump overload (stop) | 0.55kw・0.75kw | Three phase 200V | Multi-stage volute immersion pump | PT3/8, 4 ports | PT3/8, 4 ports | Approximately 10L | Supply water temperature +10℃~90℃・±0.3℃ | Approximately 50kg |
Customers who viewed this product also viewed
Other products of Igarashi Manufacturing Co., Ltd.
View more products of Igarashi Manufacturing Co., Ltd.