Hydraulic equipment oil conditioner AKZ10 series-AKZ14A (standard)

Hydraulic equipment oil conditioner AKZ10 series
Hatashige Shoten Co., Ltd.

Hatashige Shoten Co., Ltd.'s Response Status

Response Rate

100.0%

Response Time

4.9hours

Very Fast Response

About This Product

■Lightweight and compact design・Lightweight and compact transformer-less 400V specification lineup
・Since the dimensions are the same as standard products, there is no need to change the design even if the voltage is different.
- Significantly reduced volume and mass compared to the 9 series.

■Improved maintainability・Air filter structure that prevents condenser clogging due to oil mist
- Conventionally, in the case of only a filter, even if the filter was replaced and cleaned, the cooling capacity decreased due to clogging of the heat exchanger itself, so it was necessary to clean the heat exchanger once every few years.
・With the new filter, the heat exchanger will not be clogged. Cooling capacity can be maintained by replacing and cleaning the filter. (*When mist concentration is 0.5mg/m3)

■Providing predictive maintenance and communication functions *Optional- Added alarm margin to communication content. By attaching a communication option board to the oil conditioner control board and communicating with the machine side.
- Operation mode and operation settings can now be changed from the machine side.
-Allows the machine to read oil conditioner alarm codes, temperature data, etc.

In the 10 series, a new function has been added to quantify and communicate the margin until an alarm occurs. On the machine side, it is now possible to use the data to determine when it is time for maintenance.

■Continues the traditional featuresThe existing features such as energy saving, high-precision temperature control, and high reliability suitable for factory environments remain unchanged.

■Energy savingOverwhelming energy savings with a uniquely developed compressor and inverter

■High precision temperature controlHighly accurate temperature control over the entire capacity range (±0.1℃)

■Wide operating temperature rangeCan be used at room temperature of 5 to 45℃ and liquid temperature of 5 to 50℃

■Reliability (environmental resistance)Measures against dust and oil smoke (IP54 protection structure for electrical components), transport strength, sulfurization resistance of substrates, wide fin pitch to prevent heat exchanger from clogging.

■Rich functionsRefrigerant gas shortage detection, temperature warning, auto tuning function, ON timer, predictive maintenance function (maintenance timing notification, emergency operation in case of thermistor abnormality)

■Reducing environmental impactCompliant with environmental regulations, including the use of lead-free solder on printed circuit boards.

■Easily monitor operating statusRoom temperature, inlet/outlet oil temperature, and other internal data can be monitored on a computer using Hybrid-Win. Batch display of data makes it easy to understand operating status.

■Main usage examples・Machine tools Machining centers, NC lathes, grinding machines, NC dedicated machines, NC electrical discharge machines, etc.
・Industrial machinery, molding machines, presses, etc.

Model
There are 1 models for this product.

Product
Hydraulic equipment oil conditioner AKZ10 series

Handling Company
Hatashige Shoten Co., Ltd.

Categories

Cooling Equipment

Oil Coolers

40+ people viewing

Last viewed: 2 hours ago

Free
Get started with our free quotation service - no cost, no obligation.

No Phone Required
We respect your privacy. You can receive quotes without sharing your phone number.

1 Models of Hydraulic equipment oil conditioner AKZ10 series

Image	Part Number	Price (excluding tax)	Evaporator	Temperature adjustment (selectable) Fixed type Range ℃	Temperature adjustment (selectable) Fixed type Controlled object	Temperature adjustment (selectable) Synchronous type Standard	Temperature adjustment (selectable) Tuning type Tuning range °C	Temperature adjustment (selectable) Synchronized control target	Maximum power consumption/current when cooling	Exterior color	Exterior dimensions (H×W×D) mm	Compressor (totally hermetic DC swing type)	Circuit voltage Operation circuit	Circuit voltage Main circuit	Condenser	Refrigerant: R410A (GWP:2090)	Refrigerant control	Cooling capacity (50/60Hz) kW	Power supply	Scope of use Product external pressure loss	Usage range Oil viscosity mm2/s	Usage range Room temperature ℃	Usage range Inlet oil temperature ℃	Usable oil	Fan electric motor	Oil pump electric motor	Oil pump opening pressure MPa	Oil pump discharge amount L/min	Oil conditioner equivalent horsepower (HP)
	AKZ14A (standard)	Available upon quote	Cross fin coil type	5~50	Inlet oil temperature or outlet oil temperature	Room temperature or aircraft temperature (Factory setting is room temperature: mode 3)	-9.9 to +9.9 relative to standard temperature (factory set: 0.0)	Inlet oil temperature or outlet oil temperature (Factory setting is inlet oil temperature)	200V 50Hz: 0.90kW/3.9A 200V 60Hz: 0.91kW/3.6A 220V 60Hz: 0.91kW/3.5A	Ivory white	650×360×440	Equivalent to 0.4kW	DC12/24V	3 phase AC 200/200・220V 50/60Hz	Cross fin coil type	Filling amount: 0.54kg Carbon dioxide equivalent amount: 1.13tCO2eq	Compressor rotation speed + electronic expansion valve opening by inverter	1.3/1.4	3 phase AC 200/200・220V 50/60Hz	Discharge side: 0.5MPa or less Suction side: within -30.7kPa	1.4~200 (ISO VG2~32)	5~45	5~50	Lubricating oils/mineral oil-based hydraulic fluids (however, cannot be used for phosphate ester-based hydraulic fluids, water, water-soluble liquids, medicines, food, fuel, cutting/grinding fluids, etc.)	54W	0.4kW×4P	0.5	12/14.4	0.5

Customers who viewed this product also viewed

Reviews shown here are reviews of companies.

Oil con AKZ9

Daikin Industries, Ltd.

60+ people viewing

Last viewed: 4 minutes ago

Response time: 57.41 hours

Oil Coolers

Oil conditioner AKZ10

Daikin Industries, Ltd.

60+ people viewing

Last viewed: 2 hours ago

Response time: 57.41 hours

Oil Coolers

Oil cooler CFC-free EK series (using R-1234yf gas)

TOAMEC Co., Ltd.

5.0

50+ people viewing

Last viewed: 5 minutes ago

Response time: 27.43 hours

Oil Coolers

2 models listed

Hydraulic equipment AC motor type air oil cooler LAC/LAC2 series

TAIYO Co., Ltd.

110+ people viewing

Last viewed: 5 minutes ago

Response time: 57.47 hours

Oil Coolers

3 models listed

Hydraulic equipment AC motor type air oil cooler LOC3 series

TAIYO Co., Ltd.

80+ people viewing

Last viewed: 2 hours ago

Response time: 57.47 hours

Oil Coolers

3 models listed

Hydraulic equipment Hydraulic motor type air oil cooler LHC/LHC2 series

TAIYO Co., Ltd.

70+ people viewing

Last viewed: 1 minute ago

Response time: 57.47 hours

Oil Coolers

3 models listed

Hydraulic equipment DC motor type air oil cooler LDC series

TAIYO Co., Ltd.

110+ people viewing

Last viewed: 4 minutes ago

Response time: 57.47 hours

Oil Coolers

3 models listed

Hydraulic equipment offline cooler unit LAC2S series

TAIYO Co., Ltd.

110+ people viewing

Last viewed: 6 minutes ago

Response time: 57.47 hours

Oil Coolers

4 models listed

Hydraulic equipment Small air-cooled oil cooler LDRA series

TAIYO Co., Ltd.

80+ people viewing

Last viewed: 2 hours ago

Response time: 57.47 hours

Oil Coolers

3 models listed

Forced circulation oil cooler HE/HJ series

Degree Co., Ltd.

100+ people viewing

Last viewed: 4 minutes ago

Response time: 65.68 hours

Oil Coolers

3 models listed

Forced circulation oil cooler HBO series

Degree Co., Ltd.

110+ people viewing

Last viewed: 2 hours ago

Response time: 65.68 hours

Oil Coolers

3 models listed

Oil cooler HK series

Degree Co., Ltd.

100+ people viewing

Last viewed: 2 hours ago

Response time: 65.68 hours

Oil Coolers

3 models listed

See More Oil Coolers Products

Other products of Hatashige Shoten Co., Ltd.

Reviews shown here are reviews of companies.

The world's first manufacturing AI ARUMCODE

Hatashige Shoten Co., Ltd.

120+ people viewing

Response time: 4.87 hours

Element TCEG

Hatashige Shoten Co., Ltd.

120+ people viewing

Response time: 4.87 hours

Plate unit TUWP

Hatashige Shoten Co., Ltd.

110+ people viewing

Response time: 4.87 hours

Clamps

Lever unit TUWL

Hatashige Shoten Co., Ltd.

130+ people viewing

Response time: 4.87 hours

Clamps

Reel clamper/reel unit TUSR/TURG

Hatashige Shoten Co., Ltd.

150+ people viewing

Response time: 4.87 hours

Clamps

2 models listed

Inner unit TUWI

Hatashige Shoten Co., Ltd.

150+ people viewing

Last viewed: 22 hours ago

Response time: 4.87 hours

Custom clamper AUW

Hatashige Shoten Co., Ltd.

150+ people viewing

Response time: 4.87 hours

Clamps

Air unit TUSA/TUWA

Hatashige Shoten Co., Ltd.

90+ people viewing

Response time: 4.87 hours

Patmark-robot

Hatashige Shoten Co., Ltd.

$2,957.50

140+ people viewing

Last viewed: 6 hours ago

Response time: 4.87 hours

Marking Presses

Solenoid valve for various fluids Pilot operated 2 port solenoid valve (Multi-Rex valve) AD series

Hatashige Shoten Co., Ltd.

40+ people viewing

Last viewed: 7 hours ago

Response time: 4.87 hours

Hydraulic Solenoid Valves

Oil mist filter outdoor series

Hatashige Shoten Co., Ltd.

30+ people viewing

Last viewed: 3 hours ago

Response time: 4.87 hours

Mist Separators

Small lubricator A3019 series

Hatashige Shoten Co., Ltd.

30+ people viewing

Last viewed: 3 hours ago

Response time: 4.87 hours

View more products of Hatashige Shoten Co., Ltd.

About Company Handling This Product

Hatashige Shoten Co., Ltd.

Response Rate

100.0%

Response Time

4.9hrs

Japan

Related search keywords

This is the version of our website addressed to speakers of English in the United States. If you are a resident of another country, please select the appropriate version of Metoree for your country in the drop-down menu.

Hydraulic equipment oil conditioner AKZ10 series Hatashige Shoten Co., Ltd.

Hatashige Shoten Co., Ltd.'s Response Status

About This Product

■Lightweight and compact design

■Improved maintainability

■Providing predictive maintenance and communication functions *Optional

■Continues the traditional features

■Energy saving

■High precision temperature control

■Wide operating temperature range

■Reliability (environmental resistance)

■Rich functions

■Reducing environmental impact

■Easily monitor operating status

■Main usage examples

1 Models of Hydraulic equipment oil conditioner AKZ10 series

AKZ14A (standard)

Customers who viewed this product also viewed

Other products of Hatashige Shoten Co., Ltd.

About Company Handling This Product

Related search keywords

Hydraulic equipment oil conditioner AKZ10 series
Hatashige Shoten Co., Ltd.