Wet blast processing processing
Yutou Co., Ltd.

About This Product

Wet blast is a water version of "sandblast" that sprays a liquid containing an abrasive with an air. In sandblast, abrasives are sprayed with air, but wet blasts are sprayed with liquids, so there are various characteristics as shown below.

■ The heat does not applyIn sandblasting, the abrasive is blown directly in the air, which always causes heat or electricity. However, in the wet blast, not only cools the processed with the water to be sprayed, but also the generated heat and electricity escape to the water. Ideal for those that are difficult to add heat and electricity.

■ Ideal for stainless steel burnsIt seems that electrolytic polishing and buff processing are often performed to the stainless steel discharge processing and baking marks after baking. Masu. Wet blasting can reduce the cutting capacity by using water, and can take a burn mark without changing the dimensions.

* The dimensions may change depending on the weak object.

■ Because small particles can be used, complex shapes are OK.Unlike normal sandblasts, you can use extremely small particles of abrasives. Therefore, wet blast is suitable for complicated shape processing.

■ Secondary processing such as rust prevention and degreasing is realized at the same timeJust dissolve drugs such as rust prevention and degreasing in water to obtain the same effect.

■ The clogging of the old carburator is refreshingThe old carburator that is hard to fall off with chemicals can be refreshed. It is possible to wash through the holes and jets through the main, slow, and jet. Also, there is no change in the diameter of the hole.

■ The clogging of the old engine is refreshingOil burns inside the engine do not easily fall off with chemicals, kerosene, etc. With wet blasting, these can be dropped to every corner and can be removed to the oil line.