IBS Co., Ltd.'s Response Status
This product is registered by IBS Co., Ltd..
About This Product
■ Overview
・ Since the nicher part, which is a heater, is involved evenly in the entire hose, there is little variation in the inner wall temperature distribution, and the temperature range can be heated from 0 ° C to to 500 ° C.
・ Flexible hose materials are selected according to the status and conditions of use of the site. In particular, it is possible to respond to continuous use of continuous movement, such as a flexible requirement. In addition, it can be produced up to 50m, so it can be worked on a wide area. You can also design a stainless steel pipe into a hot hotto structure.
・ Up to 35MPa ultra -pressure type type (inner diameter 28.4 φ / set temperature 230 ° C) can be designed. The pressure -bearing power differs depending on the material, diameter, set temperature of the hose, and the required bending radius.
・ The material of the hose is designed mainly based on flame -retardant and non -combustible materials according to the conditions. In addition, since the heat insulation material is also selected from the material with a high heat insulation effect, the surface temperature is low and can be used with confidence.
・ You can choose according to the needs of the site, such as size (inner diameter / length), design temperature, and joint. There is also a controller that can support various hot hones for temperature control.
■ Use
・ Hot melt equipment (packaging, bookbinding, plywood, paper diapers, etc.
・ Dispenser equipment (epoxy resin, silicone)
・ Automotive -related (transfer of butyl rubber, urethane)
・ Transfer multi -layered molding (high viscosity resin (PP, PE, acrylic, PVC, etc.))
・ Related to physics and chemistry and environment (exhaust gas analysis equipment)
・ Food and medical products (transfer of chocolate, wax, oil, cosmetics, etc.)
・ Painting industry (hot air, hot spray)
・ Next -generation energy (fuel cell, optical fiber)
・ Others (Oil, grease, asphalt, tar enamel, ink, steam, dew condensation prevention, etc.)
■ Precautions for handling
・ Hot hot is not explosion or waterproof.
・ Be sure to install a leaked breaker on the power supply side.
・ Please be sure to use the temperature control with a temperature tube.
・ When flowing thermoplastic materials, do not apply pressure until the ingredients are dissolved.
・ Do not forcibly stretch the hot hose.
・ Do not twist the hot hot.
・ Approximately 100mm of hoses are bent and strictly prohibited. (Up to 1B hose size)
Share this product
