All Categories

History

FA sensor Light curtain/safety equipment Non-contact safety door switch SG-P-SG-P□-M-P
FA sensor Light curtain/safety equipment Non-contact safety door switch SG-P-Panasonic Industry Co., Ltd.

FA sensor Light curtain/safety equipment Non-contact safety door switch SG-P
Panasonic Industry Co., Ltd.


About This Product

basic information

■You can see the open/closed status of the entire facility's doors at a glance.

Obtained UL, CE, CSA, TUV, UKCA. (UL, CSA: certified by TÜV SÜD America Inc.) Features

■Large and bright indicator lights inform you of the open/closed status of the doors of the entire facility.

With the flashing function, if any one of the safety switches connected in series goes into a non-detection state, the indicator lights of the other safety switches will flash green to notify the operator.

■2 types to choose from

Visible type for doors with aluminum frame, compact type for doors without aluminum frame

■Flashing function notifies you of unsafe conditions

・The safety switch of the door that is open will turn red, and the other doors will flash green. Operators can immediately recognize the equipment status and which doors are open. ・BEFORE conventional method: Even if only one door was open, the connected safety switch would turn off, so it was necessary to check each door one by one to see which door was open. Additionally, if the switch was installed inside the door, the indicator light of the switch could not be seen from outside the device. ・[Industry's first*] AFTER SG-P series *As of September 2020, according to our research. :The safety switch of the door that is open will turn red, and the other doors will flash green. Operators can immediately recognize the equipment status and which doors are open.

■Industry's first* "Indicator light transmission method" adopted for actuator

Visible type actuators allow the light from the indicator light on the switch body to pass through and illuminate as an indicator light on the actuator side. This allows it to be used as a highly visible safety switch, even on doors with aluminum frames. *As of October 2020 Based on our research regarding safety door switches.

■Parent-child structure (standard/sub) realizes wiring savings. No dedicated controller required; up to 30 units can be connected in series

The SG-P series can output safety outputs all at once from the standard type that is the base unit (OSSD1/OSSD2). There is no extra wiring for the slave unit subtype when cascading. Additionally, a dedicated controller is not required and it can be connected directly to your safety controller/safety circuit. Up to 30 units can be connected, contributing to equipment wiring savings.

  • Product

    FA sensor Light curtain/safety equipment Non-contact safety door switch SG-P

Share this product


60+ people viewing

Last viewed: 10 hours ago


Free
Get started with our free quotation service - no cost, no obligation.

No Phone Required
We respect your privacy. You can receive quotes without sharing your phone number.

1 Models of FA sensor Light curtain/safety equipment Non-contact safety door switch SG-P

Image Part Number Price (excluding tax) DCavg PFHD Cable Check input/output Control output (OSSD1, OSSD2) Control output protection circuit (short circuit protection) Control output operation mode (output operation) Operating distance Front/Side Response time Cable length when connected Body mass Compact type Body mass Visible type Material Packing mass Pollution degree Current consumption Temperature characteristics Number of series connected units Environmental resistance Operating ambient temperature Environmental resistance Ambient humidity Environmental resistance Protective structure Environmental resistance Insulation resistance Environmental resistance Vibration resistance Environmental resistance Impact resistance Environmental resistance Voltage resistance Applicable standards North America Compliant standards International standards Compliant standards Japan Compatible standards Europe Power supply voltage
FA sensor Light curtain/safety equipment Non-contact safety door switch SG-P-Part Number-SG-P□-M-P

SG-P□-M-P

Available upon quote

99%

2.30 × 10−10

With 6-core cabtyre cable 5m

Dedicated communication line between the switch body (standard) and the switch body (sub)
*Not for external input/output. (Voltage range 0~5V DC)

PNP transistor open collector 2 outputs
・Maximum outflow current: 100mA

Equipment

・When actuator is detected (safety state): ON
・When actuator is not detected (unsafe, lockout): OFF
・When the switch body (sub) does not detect the actuator (when multiple units are connected in series): OFF

Sao (OFF → ON): 5mm, Sar (ON → OFF): 15mm

・Single unit: ON → OFF 100ms or less, OFF → ON 100ms or less
・When connecting multiple units in series: Single unit + 5ms × (Number of connected units - 1)

・When using one unit: Maximum cable length between switch body and power supply unit is 20m or less
- When connecting multiple units in series: total cable length 100m or less, maximum cable length between adjacent switch units 20m or less

Switch body (standard): Approx. 180g, Switch body (sub): Approx. 110g, Actuator: Approx. 10g

Switch body (standard): Approx. 180g, Switch body (sub): Approx. 120g, Actuator: Approx. 20g

Switch body: PBT, PC, stainless steel, EPDM
Actuator: PBT, PC (visible type only)

・Compact type…SG-P□10-M-□: Approx. 260g, SG-P□10-S: Approx. 190g
・Visible type…SG-P□20-M-□: Approx. 270g, SG-P□20-S: Approx. 210g

3

30mA or less

0.03%F.S./℃

Maximum 30 units (1 standard, 29 sub)

-10~+55℃ (However, no condensation or freezing), storage: -25~+65℃

30~85%RH, during storage: 30~95%RH

IP65 (IEC)

20MΩ or more at DC500V megger, between all charging parts and case

Durability 10~55Hz, double amplitude 1mm, 2 hours each in XYZ directions

Durability 300m/s2 (approx. 30G) 3 times in each direction of XYZ

AC1,000V for 1 minute, all live parts and between cases

CAN/CSA C22.2 No.14, UL508

ISO 13849-1:2015 (Category 4, PLe), IEC 61508-1~3 (SIL3), IEC 62061 (SIL3), IEC 60947-5-3, ISO 14119

JIS B 9705-1, JIS C 0508-1~3 (SIL3), JIS B 9961, JIS C 8201-5-2, JIS B 9710

EN ISO 13849-1:2015 (Category 4, PLe), EN ISO 14119, EN 60947-5-3, EN 300 330, EN IEC 63000, EN 301 489-1

24V DC+10-20% Ripple P-P 10% or less

Customers who viewed this product also viewed

Reviews shown here are reviews of companies.

See More Safety Devices Products

Other products of Panasonic Industry Co., Ltd.

Reviews shown here are reviews of companies.


View more products of Panasonic Industry Co., Ltd.

About Company Handling This Product

This is the version of our website addressed to speakers of English in the United States. If you are a resident of another country, please select the appropriate version of Metoree for your country in the drop-down menu.

Copyright © 2025 Metoree