Movable gas shock monitor arm
Thanko
This product is registered by Thanko.
About This Product
Although it is a simple monitor arm of three axis, the feature is the gas -type arm fixed. Normally, if you have to fix it with a wrench, etc., if you use this [Movable Gas Shock Monitor], you can fix the monitor to your preferred position and release your hand.
In addition, there are four rails in the pole part that inserts the arm. Paul is installed on the desk, and the degree of freedom in the monitor position is widened depending on the place where the rails on the front, left and right rails, and the rear rails are inserted.
■ Movement of arm
・ Movement before and after the arm
You can fix it without having to tighten the front and rear movements smoothly with a gas type
・ Arm left and right movements
It is a monitor arm with a 3 -axis arm and a gas shock that does not require fixed screw tightening. It extends up to about 90mm from the pole to the first axis, up to about 443 mm forward from the first axis to the monitor mounting part.
・ Arm left and right movements
The first axis close to the pole moves about 220 ° left and right.
・ Movement on the upper and lower arms
Just tighten with a handle lever. You can set an arm at a free height. Easy because it can be fixed with a handle lever. You can place a monitor in your favorite height and position.
* The upper and lower movable range varies depending on the situation, such as the size of the monitor and placement locations to be installed.
■ Movement of the monitor part
About 180 ° upper and lower monitors, about 180 ° left and right, rotation movement 360 °. The monitor is about 180 ° on both up, down, left and right. 。 Regarding rotation, it is possible to turn 360 °.
■ Installation unit
Fixed with two clamps (attached top plate). Can be installed on a maximum of about 96mm top plate. It is firmly fixed because it is tightened with two clamps. Since the clamp position can be adjusted up to 3 levels, it can be installed on a top plate of up to 96mm. In addition, it has a sponge rubber that enhances the fixation without damaging the desk and top plate.
■ Monitor LCD monitor back, VESA standard
Many liquid crystal monitors have a standardized arm and stand mounting dimensions to 75mm x 75mm and 100mm x 100mm. This standard is called the VESA standard. Our liquid crystal monitor arm supports all models, VESA (Video Equipment Standardization Association) standard.
■ Cable wiring clip
The cable that gets in the way on the hanging desk is clean along the arm. As much as the arm is extended, cables such as power supply and output from the monitor will interfere with the plastic. If you use the cable wiring clip on the arm, you can wire the cable along the arm and hook it without hooking.
■ How to install
Clamp club
[1] Adjust the position in consideration of the thickness of the top plate to attach the arm.
[2] Put on the top plate and tighten two clamps.
[3] Completed
Arm department
[1] Put the base of the arm along the rail in the pole attached to the top plate.
[2] At the preferred position, tighten and fix it with the handle lever.
[3] Connect the arm with the attached wrench.
[4] Put your monitor and arm on the tip monitor mounting part with four screws.
The axis of each arm can be adjusted to the desired hardness using a wrench.
By changing the position of the rail, the degree of freedom in the monitor position is expanded.
-
-
Product
Movable gas shock monitor arm
Share this product