All Categories
History
Price (excluding tax)
Response Rate
100.0%
Response Time
11.9hours
Fast Response
■Installation location Please install it indoors where there is no strong light or direct sunlight. ■Soap solution used Add commercially available water soap to the soap solution container. Do not use viscous soap solutions or soap solutions mixed with solids. When diluting concentrated soap solution, use pure water as the diluent. When diluted with tap water, the fatty acid components of the soap solution may combine with the impurities Mg and Ca ions contained in the tap water to form metallic soap, which may clog the soap pump. ■How to use Please wash your hands under the water nozzle. Correct hand washing can be performed automatically and forcibly by rinsing with water, dispensing soap, lathering, and rinsing in the specified order. ■Connection between spout and control device 1. Cut the soap solution supply pipe (outer diameter Φ6) and water supply pipe (outer diameter Φ10) connected to the spout to appropriate lengths, and insert them into the one-touch fitting at the top of the control panel (approximately 15 mm). . 2.Push in the signal wire MATE-N-LOCK connector until the lock claw engages. ■Connection between control device and soap solution container 1.Push the soap solution supply pipe connector firmly into the soap solution container receptacle until you hear a “click” sound. 2. Insert the liquid level sensor connector into the receptacle of the soap solution container with the hook lever facing you. ■How to drive a soap pump 1.Remove the control device cover. 2. Turn on the power. (When you turn on the power, the power lamp lights up and about 5 seconds later, the standby lamp lights up.) 3. After the standby lamp on the display panel above the spout lights up, tilt the lever of the test switch on the control board upwards to operate the soap pump, and release it to stop. Operate the test switch to confirm that soap solution flows from the soap solution container to the control device and from the control device to the spout, and drive the soap pump until soap solution is discharged from the soap solution discharge nozzle.
You can search for other models from each index. The displayed value is the value of the currently selected part number.
Chemical solution used
External dimensions
Interlocking output
Mass
Material
Power consumption
Power supply
Soap solution tank capacity
Soap liquid discharge amount
Washing time
Washing water discharge flow rate
Water supply
Whipping time
Soap solution discharge time
Tap water
Part Number
SH-30Handling Company
Amemiya Equipment Co., Ltd.Categories
| Image | Price (excluding tax) | External dimensions | Mass | Material | Power consumption | Power supply | Soap solution discharge time | Soap solution tank capacity | Tap water | Washing time | Whipping time |
|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
Available upon quote | W60×D175×H60mm (spout) | 5Kg | Spout: stainless steel | 30W | AC100V (50/60Hz) | 2~5 seconds (factory set to 2 seconds) | 5 liters | ~0.6Mp Connection size G1/2 | 10~30 seconds (set to 10 seconds at factory) | 10~30 seconds (set to 10 seconds at factory) |
Reviews shown here are reviews of companies.
Reviews shown here are reviews of companies.
Response Rate
100.0%
Response Time
11.9hrs
