All Categories
History
Price (excluding tax)
Response Rate
100.0%
Response Time
11.9hours
Fast Response
■Installation location Please install it indoors where there is no strong light or direct sunlight. ■Soap solution used Add commercially available water soap to the soap solution container. Do not use viscous soap solutions or soap solutions mixed with solids. When diluting concentrated soap solution, use pure water as the diluent. When diluted with tap water, the fatty acid components of the soap solution may combine with the impurities Mg and Ca ions contained in the tap water to form metallic soap, which may clog the soap pump. ■For first time use Due to its characteristics, a soap liquid pump will not suck in liquid if there is air inside the pump, so it is necessary to fill the inside of the pump with liquid. Please follow the steps below to get the soap solution to come out of the soap solution nozzle. 1. Remove the cap from the soap solution supply port and pour the soap solution into the soap solution container. 2.Remove the cover. There is a test switch on the control board, and when you flip this test switch, the soap liquid pump will operate. 3. After pouring the water soap solution into the soap solution tank, turn down the test switch and drive the soap solution pump until soap solution comes out from the soap solution nozzle. 4. Return the test switch to its original position. ■Cleaning the soap solution container The soap solution container can be removed from the stand by turning the container body to the right.Please clean the container after removing it from the stand. When you remove the soap solution container, you will see a strainer to remove foreign matter from the soap solution. If there is any dirt or foreign matter on the surface, remove it. ■How to use Basic usage: Wash your hands under the water nozzle. Correct hand washing can be performed automatically and forcibly by rinsing with water, dispensing soap, lathering, and rinsing in the specified order. ■Adjusting the sensitivity of the hand sensor Remove the cover fixing screws (6 on the bottom of the washbasin, 1 on the top of the cover) and lift the cover. The control board and hand detection sensor can now be operated.
You can search for other models from each index. The displayed value is the value of the currently selected part number.
Chemical solution used
External dimensions
Interlocking output
Mass
Material
Power consumption
Power supply
Soap solution tank capacity
Soap liquid discharge amount
Washing time
Washing water discharge flow rate
Water supply
Whipping time
Soap solution discharge time
Tap water
Part Number
SH-20SHandling Company
Amemiya Equipment Co., Ltd.Categories
| Image | Price (excluding tax) | External dimensions | Mass | Material | Power consumption | Power supply | Soap liquid discharge amount | Washing time | Washing water discharge flow rate | Water supply | Whipping time |
|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
Available upon quote | W120×D270×H160mm (wash basin body) | 3Kg | Body: stainless steel Cover: stainless steel | 30W | AC100V (50/60Hz) | 2~5mL/sec | 10~30 seconds | Up to 8 liters/min | Water temperature 1~60℃ Water pressure 0.7Mpa or less | 10~30 seconds |
Reviews shown here are reviews of companies.
Reviews shown here are reviews of companies.
Response Rate
100.0%
Response Time
11.9hrs
