Digital indicator for load measurement / control voltage / current output sensor F388A

1 Models of Digital indicator for load measurement / control voltage / current output sensor F388A

Product Image	Part Number	Price (excluding tax)	Display display	General performance external dimensions	General performance power consumption	General performance power supply voltage	General performance rush current (Typ.)	General performance usage conditions	General performance weight	Indicated portion indicated value	Input / output unit input signal	Input / output unit output signal	Number of display portions displayed	Optional SD card slot [SDC]	Options CC-Link interface [CCL]	Options DeviceNet interface [ODN]	Options Ethernet interface [etn]	Options I / O Source board [iSC]	Pulse input (open collector) Compatible sensor	Pulse input (open collector) internal count range	Pulse input (open collector) maximum input frequency	RS-232C communication interface	Save setting value set value	Setting unit setting method	Voltage / current input A / D converter	Voltage / current input accuracy	Voltage / current input analog filter	Voltage / current input analog voltage output	Voltage / current input current input	Voltage / current input voltage input
	F388A	Available upon quote	TFT color module display area: 71 (W) × 53 (H) mm dot configuration: 320 × 240 dot	96 (W) × 96 (H) × 117.3 (d) mm (including protrusion) Panel cut dimensions 92 × 92 (+1-0) mm	5 W type.	DC 24 V (± 15 %)	2 a, 10 msec (at room temperature, cold start)	Used temperature range -10 ° C to +40 ° C / Saving temperature range -20 ° C to +60 ° C humidity 85% RH or less (condensation not possible)	Approximately 1.0 kg	Load: -9,999- +9,999 Displacement: -9,999 ~ +32,000 small points: The display position is the same as the value at the time of the comparison 0.000, 0.00, 0.0, 0, 0, 0.	16 points input format: When connecting a plus komon / minuscomon shared transistor, plus komon is an NPN output type (sink type), and the minus komon is connected to a PNP output type (source type) on voltage: 12 V or more OFF voltage: 3 V or less 24 V loads: Approximately 5 meters in insulation method. Edge	16 -point output format: Sync type / source type selection (Source type is optional: [iSC]) When connecting input units such as PLC to Output transistor ON, the sink type connects plastic commercials, source type is connected to minus comics: 30 V rated current.	3 times / second fixed	Saving, restoring all set values, can be saved, restorable, measured waveform, and judgment points can be automatically saved * SD card 1 GB included	Mitsubishi (General -purpose) You can read the full -designated values that can be linked directly to the sequencer, and you can read the points that can be written.	Read, write, and write all -specified values that can be connected to DeviceNET's compobus / d to seamlessly, can be written, read all comparative waveforms, and can be written.	Read all set values, write, and read the measurement waveforms, and read points.	Output format: Source type PLC and other input units can connect minuscomons	Output: Inclumental type 2 phase output (A, B signal output) However, it can be used for single -phase output (A phase input is used, all pulse is counted as a plus direction) Output stage specification: Open collector (NPN type, VCEO = 30 V or more LC = 30 mA or more)	About 1,000,000	50 kHz	Adache -synchronous Bore rate 1,200 BPS to 38,400 BPS Read, write, read all comparative waveforms, write, and read measurement waveforms and judgment points.	C-MOS RAM backed up by noV RAM (non-volatile RAM), lithium battery	Set by analog type touch panel operation	Speed: 4,000 times / second resolution ability: 24 Bit (binary) Effective resolution: Approximately 1/30,000 for 10 V or 20 mA input	Non -linear: 0.02% / FS ± 1 DIGIT (10 V or 20 ma input) Zero Dorift: 0.2 MV / ℃ RTI or 0.4 μA / ° C.	Select low-pass filter from 10, 30, 100, 300 Hz (-6 DB / Oct.)	Output level: Approximately 0.6 V per input 1 v or input about 0.15 v Road resistor: 2 kΩ or more	-20 ~ +20 MA input resistance: about 250 ω	-10 ~ +10 V input impedance: 1 mΩ or more