Takata Precision Industry Co., Ltd.

Mold parts. We carefully listen to our customers regarding chamfering, surface roughness, etc. before manufacturing.

• Tools

• Punching Dies

This is a custom-manufactured part in response to requests from pharmaceutical manufacturers. At our company, we carefully list...

• Fastening Components

• Shaft Brackets

This is a jig part that transports the wires of electronic components. The width of the continuous groove processed by wire cut...

• Fixtures

• Jig Parts

Electric discharge machining of spline shapes and gear shapes is also possible. Electrodes are manufactured using our wire cutt...

• Drive Mechanisms & Components

• Splines

The V part is precisely finished by wire cutting, and is a part that holds the pin with precision. The outer part is polished t...

The PTP packaging punching molds we manufacture for pharmaceutical packaging processes have achieved high precision cutting per...

There are cases where it is required to process non-through hexagonal holes or complex shapes that are difficult to process wit...

■Example of titanium processing for mass-produced machine parts for beverage manufacturers This part is a component used in mas...

Metal shear knives are used for cutting hot materials. Aiming to extend its lifespan, we have repeatedly made improvements base...

This part uses the R-shaped recess on the right side of the photo to chuck (hold) the product. A gentle radius (curved surface)...

This part is used within pharmaceutical packaging equipment. In particular, the parts are knurled, and the machining accuracy i...

This nozzle is a precision part for electronic parts production lines, and has an air hole with a diameter of φ0.3 penetrating ...

After receiving the actual internal parts of an automatic machine used in a mass-production machine for a beverage manufacturer...

This part is used to seal tubes used in production machines in cosmetic manufacturing. We worked closely with cosmetics manufac...

■Technical capabilities for ultra-precision parts processing This part becomes a chuck jaw that grips wire rods of Φ1mm or less...

■About engraving results Our company has a track record of producing high-precision engravings for a variety of uses. We can al...

Used in the process of cutting the tube end of hand cream packaging. The clearance between the upper and lower blades is very i...