About This Product
FIFO mode
・ FIFO Mo can provide continuous data transfer between DI, PC memory or hard disk.
・ The memory on the board is a real FIFO buffer, and a very reliable transfer is realized.
・ Up to 700 MB/s is intended for continuous transfer speed.
Multi -record mode
・ This mode enables data collection for each trigger without restarting hardware with software.
・ DI's built -in memory is divided into segments and records data for each trigger.
Trigger sauce
-The measurement is performed by a trigger signal set separately from the signal, or a programmed pattern liga.
・ Furthermore, they are possible with those OR or and AND.
External clock
・ Sampling clocks can also be performed by external signals.
・ This signal can also be used as a refereNCE for internal sampling clocks for synchronization collection.
-In addition, this signal can also be treated as a programmable clock delay and direct sampling status clock on any frequency change or clock gap (SDR and DDR).
Geetido record mode
・ Data collection in this mode is controlled by the external gate signal.
・ When the gate signal reaches a programmed value, the number of data set before and after each gate is collected.
Time stamp
・ The time stamp is output to the time from the measurement start, the measurement trigger, and the receiving signal from the GPS.
・ This allows the collection data of the system at different positions to be measured in accurate time.
Single output mode
・ Play the on -board memory data only once. Trigger sauce is an external trigger or software trigger.
Repeat output mode
・ Output the on -board memory data continuously or until the stop command is executed.
Single repeat output mode
・ The on -board memory data is played once after each trigger. Trigger sauce is an external trigger or software trigger.
FIFO mode
・ FIFO (streaming mode) is designed for continuous data transfer between cards and PC memory.
-The PCI Express X4 Gen1 interface can be output up to 700MB/s streaming speed.
Multi output mode
・ Each trigger can output hardware without restarting hardware.
・ On -board memory is divided into several segments, and each segment can include different data.
Getido output mode
・ Data regeneration controlled by the external gate signal is possible.
・ The data is played only when the gate signal reaches the programmed level.
Sequence mode
・ The on -board memory can be divided into several data segments of different lengths.
・ These data segments are chained in the order selected by the user using additional sequence memory.
・ In this sequence memory, you can program the number of loops of each segment and define trigger conditions from segment to segments.
-If you use a sequence mode, it is possible to switch between playback waveforms with a simple software command, or redefine the segment waveform data at the same time while playing other segments.
・ All functions related to trigger and software commands are functioning only with a single card.
32 Channel Digital I/O ~ 125ms/S
・ 32 Digital I/O channel
・ Sampling speed 1 ks/s ~ 125 MS/s
・ PCI Express X4 Interface
・ 110Ω input impedance selection can be selected
・ 3.3V and 5.0V TTL input
・ Onboard memory 1 GBYTE
・ 700 MB/S FIFO mode
・ Synchronous connection to 16 cards
-
-
Product
M2P 7515 32 Channel DIO