Up to 32 test programs can be created electric tester Ioniq20
Atech Co., Ltd.
About This Product
■ Introduction case
Pouch -type battery cells, motor coil coils, resin caps, resin bottles, resin packages (food and cosmetics), etc.
■ Measurement principle
・ Measure the current flowing between the earth plate installed on the other side with the discharge probe (patent acquisition) and the work.
-The percentage of the reference voltage and the measured voltage (reflected in the discharge current) is measured and pass / fail.
・ In the case of passing (Fig. 1): If there is no pin hole or vulnerable part, the measurement voltage and the reference voltage are almost equal, so the high measurement result (%) is displayed. It exceeds the pass / fail criteria and is determined to pass the inspection.
・ In the case of a failure judgment (Fig. 2): The measured voltage is significantly lower than the reference voltage, so the low measurement result (%) is displayed. It is declined below the pass / fail criteria and is judged to fail.
・ Test restrictions: (1) discharge probe -work -The distance of the earth plate is short (2) Electrical insulation is secured for the surrounding environment
■ Features
・ Built -in high -voltage generator (5-27.3kv)
・ Pass / fail judgment function by%display of measurement results (0 to 100%)
・ Monitoring and protection function of high voltage generator
・ Restriction of output current value
・ High -speed inspection: Cycle time with the fastest 0.6 seconds
・ Equipped with I/O port (tester control and test results output)
・ Up to 32 test programs can be created
·Remote control
・ Others: Language selection, test customization, etc.
■ Interface
Remote control program settings
I/O ports corresponding to PLC control (7 input/5 output)
・ Input: Photo coupler
Up to 24v --10mA or dry contact
・ Output: Relay output
Up to 48V/200ma
■ Optional
Master resistance module (2 points)
-
-
Product
Up to 32 test programs can be created electric tester Ioniq20