Benda Kogyo Co., Ltd.

A three-phase alternating current generator mainly used in automobiles. We manufacture finished alternators by combining compon...

• Power Supplies

• Generators

It has the function of transmitting starter motor power to the crankshaft when starting the engine. Nowadays, with the addition...

• Drive Mechanisms & Components

• Ring Gears

A ring used to ensure the strength of the housing. There is a notch on the inner diameter that follows the housing shape. ■App...

By setting a threshold (operation/stop) for current data and processing it with dedicated software, it is possible to visualize...

• Business Efficiency Systems / Software

• Factory Visualization Softwares

By using a current sensor, you can measure the current consumption of equipment. Measured data can be visualized on the web, al...

• Business Efficiency Systems / Software

• Factory Visualization Softwares

Field coil for starter. Fusing and connecting flat wire wound products with wading wire. The brush and terminal lead wire are a...

By analyzing the acquired data with dedicated software, you can visualize the daily operating status in detail, and automatical...

• Business Efficiency Systems / Software

• Factory Visualization Softwares

By shortening the current measurement cycle, the relationship between load (current) and time during machining can be determine...

• Business Efficiency Systems / Software

• Factory Visualization Softwares

A ring attached to the torque converter. Screw holes are machined for drive plate installation. A ring that can be attached to ...

Parts that can be attached to the flywheel or drive plate. It has missing teeth in certain areas, which allows it to detect the...

This is the basic type with a wireless stop reason transmitter added. Since you can obtain any nine types of stoppage reasons a...

• Business Efficiency Systems / Software

• Factory Visualization Softwares

In the hot process, heat is applied to the wire, and in the cold process, the round cross section is transformed into an irregu...

• Metallic Materials

• Rolled Steel

Added wireless display box (operation, cycle stop, stop for N minutes or more, etc.) to the basic type. Install it anywhere in ...

• Business Efficiency Systems / Software

• Factory Visualization Softwares

Mainly used for manual transmission vehicles. A part that connects the engine and clutch. Recently, there has been an increase ...

Power module case used for BEV inverters. The flange and cooling fins are joined using FSW processing.

It is a simple type that only requires installing a sensor on the equipment, and the presence or absence of operation and the v...

• Business Efficiency Systems / Software

• Factory Visualization Softwares

Stopper used for starters. It can be assembled into the armature section. Processed using a lathe equipped with a bar feeder.

Motors used in truck cabin tilt mechanisms.

Used in AT vehicles. A component that connects the engine and torque converter. A ring gear can be attached to the outer periph...

Mission parts for CVT.

Kumi contact case used for starters. A part that is assembled into the mag switch section and receives electricity from the bat...

Gear case used for starters. We carry out machining and metal press-fitting of die-cast products. The yoke part and mag switch ...

A coil built into a no-fuse circuit breaker. It supports bobbin winding, hollow winding, fusing, enamel removal, preliminary so...

Mount for high pressure fuel pump position control.