912K | Hot melt adhesive
Sanyo Life Material

Price (excluding tax)

Model Description

■Features and uses High heat resistance UL94V-2 equivalent ・ Fixed / anti -vibration reinforcement of electronic components on the foundation (PC board). ・ Reinforcement and insulation of soldering portions. ・ Filling and insulation and sealing of the coil, connector and harness unit. ・ Wire cable unity and fixed -loosening prevention. ■TN-EM30WD-H1147-EX HF read/write head For explosion-proof areas or areas with extraordinary requirements (e.g. food industry) ・M30×1.5, cylindrical type ・Stainless steel, 1.4404 ・Front cap made of liquid crystal polymer ・High protection grade: IP69K ・Special double lip sealing ・Protection against common acidic and alkaline cleaning agents ・Suitable for food industry applications ・Uses laser engraving with extremely low risk of destruction ・Power supply and operation are possible only when connected to the BLident interface. ・M12×1 connector, only connected by BLident extension cable ・ATEX, Category II3G, Ex Zone 2 ・ATEX, Category II3D, Ex Zone 22 ■TN-EM30WD-H1147-EX/C53 HF read/write head For explosion-proof areas or areas with extreme requirements (e.g. food industry) and for bus line topologies with TBEN-* ・M30×1.5, cylindrical type ・Stainless steel, 1.4404 ・Front cap made of liquid crystal polymer ・High protection grade: IP69K ・Special double lip sealing ・Protection against common acidic and alkaline cleaning agents ・Suitable for use in the food industry ・Uses laser engraving with very little damage ・No terminating resistor (separate terminating resistor is required) ・This device can only operate when connected to TBEN-S*-2RFID-* or TBEN-L*-4RFID-* using line wiring. ・Up to 32 nodes/lines or connections ・Requires corresponding terminating resistor (see accessories) ・Observe the performance of the power supply and the maximum current capacity of the cable, especially when turning on the power ・Ensure that the voltage drop on the line is within the specified range. ・Spur line: max. 2m ・Maximum bus length: 50m ・By default, commands can only be processed by one read/write head, so HF bus mode is suitable for static and slow dynamic applications ・In continuous HF bus mode, commands are executed simultaneously on all read/write heads in the bus topology. The recorded data is stored in the module's ring buffer ・Read/write heads are automatically assigned addresses ・Addresses can be parameterized for different application requirements ・Power supply and operation are possible only when connected to the BLident interface. ・M12×1 connector, only connected by BLident extension cable ・ATEX, Category II3G, Ex Zone 2 ・ATEX, Category II3D, Ex Zone 22